Large Manual Jack Plate (up to 50hp motors with trim and tilt and standard BIA bolt pattern)

Large Manual Jack Plate (up to 50hp motors with trim and tilt and standard BIA bolt pattern)

$650.00

FREE SHIPPING!

0-50hp Jack Plate (230 pound weight limit)

Available on backorder

Description

On The Fly Jack Plates are the fastest manual jack plates on the market. Our jack plates can be raised and lowered by a manual handle while on the water within seconds from top to bottom. The biggest benefit of our jack plate is TIME because every second counts out on the water! Cut your time adjusting your manual jack plate from 20 minutes to just seconds!

• Approved for up to 50hp motors (for motors with factory trim and tilt)
• Our custom manual jack mounts inside the jack plate housing
• 3 year warranty on the jack plate housing
• 1 year warranty on the jack
• Pre-drilled for transom mounting and motor mounting with standard BIA bolting pattern
• Jack plate housing made in the USA

WEIGHT: 30.6 lbs

JACK PLATE DIMENSIONS:
• Height – 10 1/2”
• Width (Transom Side) – 16 1/8”
• Width (Motor Side) – 17”
• Set Back – 5 1/4” (total length from from of transom side to the back of the motor slide)
• Motor Plate Height – 13 3/4”

MAX RISE (travel): 5 1/2 inches of travel. Plus, depending on where you mount the jack you can get up to 8 inches of rise.

ACCESSORIES NOT INCLUDED: Transom mounting accessories are not included in purchase. On The Fly Jack Plates recommends
• 4 each ½”- 3 1/2” long bolts – stainless steel
• 4 each ½”- lock nuts – stainless steel
• 8 each 1/2’”-flat washers – stainless steel
• Motor Clamp Spacers

***PATENTED***

Large Manual Jack Plate (up to 50hp motors with trim and tilt and standard BIA bolt pattern)

Additional information

Weight 33 lbs
Dimensions 12 × 17 × 6 in

1 review for Large Manual Jack Plate (up to 50hp motors with trim and tilt and standard BIA bolt pattern)

  1. Jason Stewart (verified owner)

    Easy to install and works great

Add a review

Your email address will not be published. Required fields are marked *

Large Manual Jack Plate (up to 50hp motors with trim and tilt and standard BIA bolt pattern)

Scroll to top