Manual On the Fly jack Plate (Black Anodized)

$600.00

0-30hp Jack Plate (does not fit on 25-30hp motors with factory electric trim and tilt)  150 pound weight limit

READ DISCRIPTION OF MEASUREMENTS TO MAKE SURE YOUR MOTOR WILL FIT OR GIVE US A CALL. 

2 in stock

Category:

Description

  1. DESCRIPTION:

On The Fly Jack Plates are the fastest manual jack plates on the market. Our jack plates can be raised and lowered by a manual handle while on the water within seconds from top to bottom.

• Approved for up to 30hp motors (for motors without factory trim and tilt)
• Our custom manual jack mounts inside the jack plate housing
• 3 year warranty on the jack plate housing
• 1 year warranty on the jack
• Pre-drilled for transom mounting
• Jack plate housing made in the USA

WEIGHT: 25lbs

JACK PLATE DIMENSIONS:
• Height – 11”
• Width (Transom Side) – 12 ½”
• Width (Motor Side) – 13 ¼”
• Set Back – 4 ¼” (between the transom bracket and the motor slide)
• Motor Plate Height – 12 ½”
• Motor Mounting Plate (Inside Brackets) – 10 ¾”

MAX RISE (travel): 5 3/4 inches of travel. Plus, depending on where you mount the jack you can get up to 8 inches of rise.

ACCESSORIES NOT INCLUDED: Transom mounting accessories are not included in purchase. On The Fly Jack Plates recommends
• 4 each ½”- 3 1/2” long bolts – stainless steel
• 4 each ½”- lock nuts – stainless steel
• 8 each 1/2’”-flat washers – stainless steel
• Motor Clamp Spacers

***PATENTED***

Manual On the Fly jack Plate (Black Anodized)

Additional information

Weight 24 lbs
Dimensions 14 × 14 × 6 in

Reviews

There are no reviews yet.

Be the first to review “Manual On the Fly jack Plate (Black Anodized)”

Your email address will not be published. Required fields are marked *

Scroll to top